![]() I purchased three redwood 4x4's and fifteen 6" Lags to anchor to the wall. After looking through as many books and catalogs as I could and checking what I could find on the various forums I decided to go with black pipe covered with pipe insulation. I recently was faced with the same task of choosing a design for an eight foot space I had set aside for storing lumber and sheet goods. Shop Notes and Wood also had a nice storage design. Smaller sheet stock is stored in other areas of the shop. I also try to buy sheet goods on an as needed basis. ![]() I have to store my full sheets in the garage. ![]() The area underneath is for tools (i.e., jointer, planer, sander, etc.). Right now I have about 500-600 bdft stored and totally out of my way. This may be more expensive then the steel bars, but I have more flexibility. I can just adjust the brackets to fit my needs. As my lumber supply changes (long boards, wide boards, scraps, skinny boards, etc. I use long shelf brackets on the top level and when I get the lower part I use brackets that are 6-10". I skipped studs, and they work fine, but I plan on going back some day and add hangers on the in between studs. I mounted them through the wall board and into the studs that are on 16" centers. The wall hangers were 36" long I believe. I went to HD and bought some heavy duty adjustable brackets and hangers. I have a basement shop and have to utilize space efficiently. I tend to buy for the project, and keep two projects worth at a time, and don't keep much extra on hand, so I don't need too much space.Īny and all insights would be appreciated. My ceiling height is just over 7 and a half feet and I don't have that much room. The area below 4 feet will be reserved for plywood and scraps.ĭoes this sound right? What size pipe to use 3/4, 1/2? Any problem with the pipe marking up the wood? Then slide in 16 inch lengths of black pipe. Each stud/pair will have 3 holes drilled up 5 degrees from horizontal at 4' 2", 5' 5", and 6' 8". Put up vertical 2x4's (doubles?) just like a newly studded wall 24 inches on center (should it be less/more?). I remember reading on the pond that others have used black pipe and 2x4 material, but before I do this can someone walk me through the process. In my shop re-construction I've allocated an 8 foot stretch of wall that I had planned to put in some simple lumber storage.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |